1预埋轨道

1 pre buried track

2

Two

固定门体：将门体放入轨道，尾部的底撑用专用固定卡及地脚膨胀螺钉（M12×80）固定。

The fixed door body: the door body is put into the track, the bottom support of the tail is fixed with the special fixed card and the foot expansion screw (M12 x 80).

3

Three

限位开关：按照设定门体的开、关位置埋设限位装置。

Limit switch: set up the limit device according to the opening and closing position of the set door.

4

Four

固定控制盒：控制盒可以装在机头箱内，也可移至离主机10米之内的室内。

Fixed control box: the control box can be installed in the head box, and can also be moved to the room within 10 meters from the host.

5

Five

连接线路：严格按接线图依次接好相对应的连线（严禁在通电状态下接线），接线要牢固，端子与端子之间不能短路，并捡查线路是否正确。

Connection line: strictly connect the corresponding connection line according to the wiring diagram strictly (strictly prohibit the connection in the electrified state), the connection must be firm, the short circuit between terminals and terminals, and check whether the line is correct.